The condenser fan motor is located underneath the refrigerator near the back. The condenser fan motor draws air over the condenser coils to cool them. If the refrigerator is not cold enough there might be something caught in the condenser fan motor blade, or the condenser fan motor might be defective. If the fan is not working, no cold air will get to the refrigerator compartment. If there is only one evaporator it is in the freezer side. The evaporator fan motor circulates the cold air from the coils thru the compartment. The refrigerator may have one or more evaporator fan motor(s) depending on the model and evaporator locations. Every refrigerator has a set of coils called and evaporator. If the refrigerator is not cold enough, the evaporator fan motor might have failed. If the coils are dirty enough, the unit will never be cold enough and will not be able to cool the inside of the refrigerator to the proper temperature. As the coils get dirtier the refrigerator becomes less efficient, which makes it work harder to cool down. The condenser is like a radiator and must stay clean in order to dissipate the heat which was removed from the inside of the refrigerator. If the refrigerator is not cold enough the condenser coils may be dirty. Good luck to you! You are going to need it! The cost for me was $125.00 for the building inspector and I ended up using a saddle tap/Schrader valve and recharging my refrigerator with R134a with Stop Leak from my local auto parts store. Hire a State certified building inspector and tell them of your suspicions and have the document their finding and you can photo what they find. I know that places where there were building booms like SW Florida and Arizona experienced many Chinese Drywall issues. Aluminum doesn't show the damage as it does with copper. It eats copper and aluminum like I can't tell you.
This problem occurred from builders using cheap materials from China starting roughly around 2005-2006 and beyond. You sound like your house has Chinese Drywall just as mine did. You might ask where the sulphur comes from. Likely your tubes are black from the sulphur. I can tell you what the repairman meant and no he wasn't trying to pull a fast one. Exit the mode by pressing the Lock button.In response to Kathy Gibbard. Once the operating time appears on the display, you know you have seen all the error codes indicating a fault with the Kenmore refrigerator. However, if the display shows a code, note it and continue pressing the freezer temp button to check for more error codes. But if there are no errors, the operating time will remain on the display. Keep moving by pressing the freezer temp button once if there are error codes, they will be displayed.
You will see the operating time on the display and when you do, continue by pressing the freezer temperature button six times to get through checks on the temperature sensor.Īfter this, you will see the time left until you have to replace the water filter. Next, press the refrigerator and freezer buttons and hold them while you press the Acela Ice button five times. Press the Lock button and hold it for about three seconds.
KENMORE MULTI AIRFLOW SYSTEM FRIDGE CONTROL PANEL CODES HOW TO
But if you own a newer Kenmore refrigerator model, here is how to enter the mode: Not all Kenmore refrigerators have a diagnostic mode. Get Instant Help - Ask An Experienced Verified Appliance Technician Kenmore Refrigerator Modes – Diagnostic Mode.Kenmore Refrigerator Modes – Energy Saver Mode.Kenmore Refrigerator Modes – Sabbath Mode.Kenmore Refrigerator Modes – Defrost Mode.Kenmore Refrigerator Modes – Diagnostic Mode.
0 kommentar(er)
